The Fanbus

Quick Installation Guide: Fanbus

1. Remove materials from boxes, and clear an area to work with the appropriate tools.
2. Measure the placement for the speaker terminals, and drill holes on each side in the appropriate places. Remember to make room to screw it on. Drill a hole on either end for the outgoing ground and 12v wires.
3. Attach speaker terminals.
4. Cut four strips of black wires (2-3 inches will do) and strip both ends. Do the same with some red wire. (any color of wire works, I’m just denoting the ones in the kit)
5. Solder all red wire to the red terminals, do the same for black.
6. Connect all the red wires together with solder, plus a long red wire that will be long enough to reach to the power supply cable. Do the same with the black wires.
7. Make sure all connections are secure and insulated, and route the two main 12v and ground wires out the side hole. Close up the box.
8. Put Molex pins on the two wires (I like to twist them, saves room and makes it look better) then place a male Molex connector on the end. You should be good to go.
9. Use double sided tape or Velcro to secure the unit. Put the ground wires in the black terminals and 12v in the red.
10. I hope you had fun on the project, I am happy to supply you with the materials to do so. If you have any questions, comments, or just think your Fanbus rules, contact me at cole_NOSPAM@directron.us (remove _NOSPAM manually). Thank you.

For a more in-depth guide with pictures, be sure to check out the article section of CaseEtc and look for the appropriate article. http://www.directron.com/caseetc.html