Linksys WAP200 Wireless-G Access Point, w/ Power Over Ethernet and RangeBooster
High-Speed wireless access for existing networks!
RangeBooster technology is a compatible add-on to standard Wireless-G which increases your wireless network's range up to two times, and its throughput by up to 35%. Unlike ordinary wireless technologies that are confused by signal reflections, RangeBooster uses two smart receivers at each end to detect and decode reflected signals at distances where standard technologies give up. You'll find that "dead spots" in the wireless coverage area are reduced, too.
The Advanced security features makes this solution ideal for your Business. Advanced wireless security using Wi-Fi Protected Access (WPA2 Enterprise) with up to 256-bit encryption, and the new Wireless Security Monitoring functionality gives your business the visibility and protection it needs. Used when Linksys 200-Series Wireless Adapters are present, the Wireless Security Monitoring functionality alerts you of possible wireless intruders, vulnerabilities in the wireless deployment, and visibility into Denial of Service attacks.
Features:
Standards-based POE (IEEE 802.3af) or External DC power.
RangeBooster technology for up to twice the range, reduced dead spots, and up to 35% more throughput than standard Wireless-G.
Advanced wireless security using Wi-Fi Protected Access (WPA2) with up to 256-bit encryption, and new Security Monitoring Feature gives your business the visibility and protection it needs.
Support for WMM provides improved QoS over wireless connections for better video and voice performance.
Specifications:
Model: WAP200.
Standards: IEEE802.11g, IEEE802.11b, IEEE802.3, IEEE802.3u,
IEEE802.3af (Power Over Ethernet), 802.1p (QoS priority),
802.1q (VLAN), 802.1X (Security Authentication),
802.11i: Ready (Security WPA2), 802.11e: Ready
(Wireless QoS), 802.11F (Wireless Roaming).
Connectors: 10/100 Base-T Ethernet, 12 VDC Power.
Buttons: Reset.
Cable Type: UTP Category 5.
Indicators: LEDs for Power, PoE, Wireless, Ethernet.
Oper. System: Linux.
Setup/Config.: WebUI: Built in Web UI for Easy browser-based configuration
(HTTP/HTTPS).
Management: SNMP Version : SNMP Version 1, 2c, 3.
Event Logging : E-mail Notification.
Remote Syslog.
Web F/W upgrade: Firmware Upgradable Through Web-Browser.
Diagnostics : Flash, etc. Diags: Flash, RAM, LAN, WLAN.
DHCP: DHCP Client.
Operate Modes: Access Point: Access Point Mode, point-to-point Bridge
Mode, point-to-multipoint Bridge Mode,
Repeater Mode.
Wireless: Spec/Modulation: Radio and Modulation Type: 802.11b/DSSS,
11g/OFDM.
Channels: 11 North America.
13 Most of Europe (ETSI and Japan).
Antenna: (2) External Antennas (Omni-Directional)
SMA detachable.
Transmit Power: Transmit Power (Adjustable) @ Normal Temp.
Range: 11b: 18 dBm; 11g: 14 dBm.
Antenna Gain: 2 dBi.
Receiver
Sensitivity: 11.g: 54Mbps@ -72dBm.
11.b: 11Mbps@ -85dBm.
Security: WEP/WPA/WPA2: WEP 64-bit/128-bit, WPA-PSK, WPA2-PSK,
WPA-ENT, WPA2-ENT.
Access Control: Wireless Connection Control: MAC-Based.
SSID Broadcast: Enable/Disable.
802.1X: IEEE 802.1X support.
Wireless Client
Isolation: Wireless Client devices can be isolated
from each other, either within an SSID
or between two SSIDs.
Wireless
Security: Monitor Scan and Classify wireless devices
in the network.
Report new client and AP joining network
and suspicious network events. (Works
together with 200 Business series client
adapters):
1. Intrusion Alarms (e.g., Rogue Client
Detected, Spoofed MAC address).
2. Denial of Service Alarms (e.g.,
Duration Attack, Association Table
Full).
3. Vulnerability Alarms (e.g., AP is
not using encryption, AP is
broadcasting SSID).
4. Other Alarms (e.g., Low speed
connection).
QUALITY OF SERVICE:
QoS: 4 Queues.
WMM Wireless priority.
General: Wireless roaming based on IAPP.
Load Balancing.
Auto-channel selection.
Requirements: 802.11b, 802.11g Wireless Adapter With TCP/IP Protocol
Installed Per PC.
Switch/Router with Power Over Ethernet (PoE) Support Or PoE
Injector when used with PoE.
Web-Based Configuration Java-Enabled Web Browser.
Approvals: FCC, ICES-003, CE.
Power Source: 12V 1A DC input, and IEEE 802.3af Compliant PoE.
Dimensions: 6.69"w x 8.07"h x 7.68"d.
Minimum System Requirements:
802.11b, 802.11g Wireless Adapter With TCP/IP Protocol Installed Per PC.
Switch/Router with Power Over Ethernet (PoE) Support Or PoE Injector when used with PoE.
Web-Based Configuration Java-Enabled Web Browser.
Package Contents:
Wireless-G Access Point with Power Over Ethernet and RangeBooster.
2 x SMA detachable Dipole antenna.
User Guide on CD-ROM.
Ethernet Network Cable.
Power Adapter.
Product Stands.
Registration Card.
Limited Warranty: One year from invoice date with Directron.com. 3-year from invoice date with manufacturer. 30-Day money back from receiving date with 15% restocking fee for non-defective returns. No credit or refund after 30 days. Customer is responsible for returning defective products including DOA due to manufacturer unless testing is paid before shipping. (Alice-101107)